Power Recline - Quickie Xplore 2 Hybrid Owner's Manual

K. Power Recline (Std. Operating Instructions)
WARNING!!!
Make sure the wheelchair is on a level surface before
proceeding with recline mode.
Increasing Recline Angle with 4-way Toggle
Pull the four-way toggle switch back towards the rear of
the wheelchair until the desired recline angle is achieved
and release.
Increasing Recline Angle with Push Button Switches
rd
Push the 3 button furthest from the wire until the desired
recline angle is achieved and release.
Decreasing Recline Angle with 4-way Toggle
To reverse the recline angle direction: Release the four-
way toggle switch to the neutral position for a minimum of
1 second and pull the four-way toggle switch back
towards the rear of the wheelchair until the desired recline
angle is achieved and release.
Decreasing Recline Angle with Push Button Switches
rd
To reverse the recline angle direction: Release the 3
button furthest from the wire to the neutral position for a
minimum of 1 second and push the same button until the
desired recline angle is achieved and release.
Mercury Limit Switch
When equipped with a Tilt and power or manual recline
combination, your wheelchair will include a mercury
switch located inside the shroud, on the right side of the
chair. The purpose of the mercury switch is to control the
combination of the total tilt / recline angle.
This mercury switch can be manually turned to change
the total tilt / recline angle to a desired or comfortable level
for the end user. The total tilt and recline angle should
never exceed the horizontal plain (180 degrees).
Technicians must watch for a possible tilt actuator behind
the seat that would reduce the total tilt / recline limit. The
total tilt and recline angle should be limited prior to contact
between the shroud and the tilt actuator.
Quickie Xplore 2 Owner's Manual Rev. A 23