Table of Contents
Advertisement
E L A N H O M E S Y S T E M S
Factory Default
When your D400 arrives, it is set to a FACTORY
DEFAULT condition. At some point during the life
of this amplifier it may be necessary to put the
unit back into Factory Default mode. If this unit is
moved to a different location or speaker type or
load are changed, the FACTORY DEFAULT proce-
dure should be used:
1. Turn the D400 OFF using the rear Power
Switch.
2. Turn the unit back ON. The Front Display will
read ELAN.
3. Press and hold C+, C-, V+, and V- (all the
front panel buttons at once) while ELAN is
displayed.
4. The Front Display will now read "FACTORY
DEFAULT".
The Factory default settings are:
• All channels Volume defaults to 50.
• Lockout feature is Disabled.
• ACE ™ Automatic Clip Eliminator is Enabled.
Display Brightness Levels
The blue Signal and Power LED brightness levels
on the Display can be increased or decreased
from the Front Panel. Press and hold C+ and V+
to cycle between High, Low, and Off. The red
Clipping LEDs cannot be adjusted.
© ELAN Home Systems 2005 • All rights reserved.
D400/D401
INSTALLATION MANUAL
Page 17
Hide quick links:
Advertisement
Table of Contents
