Where To Put The Fd Terminal; Loading The Paper; Installing The Ink; Get Connected - First Data FD200Ti Quick Setup Manual

Let's get started...
Typical set-up time: 5–10 minutes

Where to put the FD Terminal

Place the terminal on a desk or tabletop. Avoid areas with
direct sunlight, objects that radiate heat, excessive dust and
other electrical devices that can cause excessive voltage.

Loading the paper

Pop the printer cover's latch to open the cover; then lift the
cover. Load a roll of paper (Appleton POS Grade Plus 600-2.4
is recommended) into the printer. The thermal print-side of
the paper will feed out facing the operator. Close the cover
and tear off any excess paper.

Installing the ink

Gently press the ink tray latch at the side of check reader of
FD200 , and then the ink tray cover pops open. Push the black ink
Ti
tray, and then flip the ink tray left gently. Put the new ink cartridge
into the tray and lift the lever up to fasten the ink cartridge.

Get connected

You may choose an IP connection (DSL or cable) or dial-up. If you
choose dial-up you can use a dedicated phone line, the same line
as your fax machine or any other jack not plugged into a phone
system or LAN (Local Area Network).
6