Table of Contents
Advertisement
Initial switch-on: Software will be installed
Initial switch-on: Software will be installed
If the server is connected to a network, the network protocol is required as well as the user and
server details. Contact your network administrator if you have any questions about these settings.
When you switch on your server for the first time, the supplied software is installed and configured.
You should plan some time for this, as this process must not be interrupted.
CAUTION!
!
Once the installation has been started the server must not be switched off!
During installation the server may only be rebooted when you are requested to do so!
Otherwise the installation will be not be performed correctly. If a fault occurs during the
installation, the contents of the hard disk must be completely restored.
You may require the Windows license number during installation. This number is located on a sticker
on your server.
Switching on monitor and server
Ê
Switch the monitor on (see the operating manual for the monitor).
Ê
Switch your server on. To do this, follow the instructions below.
Additionally to the ON/OFF button on the front, a main switch at the rear of the server is
i
provided.
A26361-K831-Z502-1-7619
Preparing for use
11
Advertisement
Table of Contents
