Removal Of Propeller Fan And Fan Motor - Daikin RZQ100B8V3B Service Manual

Disassembly and Maintenance: Outdoor Units
1.2.2

Removal of Propeller Fan and Fan Motor

1
Warning
Procedure
Step
Remove the front and top
panels in accordance with the
Removal Procedure for
Outside Panel.
1 Remove the propeller fan
3
1 Unscrew the four screws
that fix the air discharge
grille and disengage the
four clicks at the top and
bottom of the grille, and
then remove this air
discharge grille.
2 Unfasten the fan lock nut
that fixes the propeller
fan.
5 5
2 Remove the fan motor
1 Remove the connector
(*) for the fan motor from
the PC board.
(*) Symbol of connector:
RZQ71B8V3B: X206A
RZQ100~140B:
X206A, X207A
2 The lead wire is clamped
in three places. (Click on
partition plate×3 places)
3 Unscrew the three
screws that fix the front
panel and then pull up
the lead wire.
4 Unfastening the four lock
bolts from the fan motor
enables the removal of
this fan motor.
5–6
Be sure to wait 10 minutes or more after turning off all power supplies before disassembling work.
Procedure
Propeller fan
Click
Click
Fan lock nut
Air discharge grille
Connector for fan motor
Clamp
Screws
(three
numbers)
Bolts (four numbers)
Points
In order to disconnect the
connector, do not pull the lead
wire. Hold the connector part
and then push the clicks.
Lead wire Propeller fan
Cautions in mounting the
motor
Be sure to fix the motor lead
wire with a clamp. Not
heeding this caution will cause
the entanglement of the lead
wire around the fan, which will
result in damage to the fan.
Part 5 – Disassembly and Maintenance
ESIE05-03