Operation Using Advanced Key Functions - Mazda speed 6 2007 Manual

CAUTION
When leaving the vehicle, make sure
the ignition switch is turned to the
LOCK position.
NOTE
When turning the ignition switch to
l
the LOCK position, the ignition
switch has to be pushed in from the
ACC position and turned. Without
being pushed in, the ignition switch
stops at the ACC position and the
vehicle battery may be discharged if
the ignition switch is left in the ACC
position. When leaving the vehicle,
make sure the ignition switch is
turned to the LOCK position.
If the vehicle is left with the ignition
l
switch not in the LOCK position, a
beep sound is heard and the indicator
light flashes to notify the driver.
Refer to Warning Beep (page 3-16).
Advanced Keyless Entry and Start System
Operation Using Advanced
Key Functions
qKeyless Entry System
This system remotely locks and unlocks
the doors and the trunk lid, and opens the
power windows.
It can also help you signal for attention.
Press the buttons slowly and carefully.
NOTE
The keyless entry system is designed
l
to operate up to about 2.5 m (8 ft)
from the center of the vehicle, but
this may vary due to local
conditions.
The system does not operate when
l
the ignition switch is not in the
LOCK position or the start knob is
pushed in.
With the start knob installed in the
l
LOCK position, the system is fully
operational. If the ignition switch is
not in the LOCK position or the start
knob is pushed in, the system does
not operate.
All doors and the trunk lid cannot be
l
locked by pressing the lock button
while any door or the trunk lid is
open. The hazard warning lights will
also not flash.
If the transmitter does not operate
l
when pressing a button or the
operational range becomes too small,
the battery may be dead. To install a
new battery, refer to Maintenance
(page 3-5).
Knowing Your Mazda
3-13