Operation Using Advanced Key Functions - Mazda Mazdaspeed3 Manual

Operation Using Advanced
Key Functions
qKeyless Entry System
This system uses the more traditional
keyless entry buttons to remotely lock and
unlock the doors and the liftgate, and
opens the trunk lid.
It can also help you signal for attention.
Press the buttons slowly and carefully.
NOTE
The keyless entry system is designed to
l
operate up to about 2.5 m (8 ft) from the
center of the vehicle, but this may vary due
to local conditions.
The system does not operate when the
l
auxiliary key is in the key slot.
The keyless entry system is fully operational
l
when the push button start is switched off.
The system does not operate if the push
button start is switched to any position
other than off.
All doors and the liftgate cannot be locked
l
by pressing the lock button while any door
or the liftgate is open. The hazard warning
lights will also not flash.
If the transmitter does not operate when
l
pressing a button or the operational range
becomes too small, the battery may be
dead. To install a new battery, refer to
Maintenance (page 3-5).
Advanced Keyless Entry and Start System
Transmitter
Lock button
The operation indicator light flashes when
the buttons are pressed.
Lock button
To lock the doors and the liftgate, press
the lock button. A beep sound will be
heard once and the hazard warning lights
will flash once.
To confirm that all doors and the liftgate
have been locked, press the lock button
again within 5 seconds. If they are closed
and locked, the horn will sound.
The system can be set not to sound the
horn.
Refer to Personalization Features on page
10-10.
Knowing Your Mazda
Operation indicator light
Unlock button
Trunk button (4 door)
Panic button
3-17