Operation Using Advanced Key Functions - Mazda RX-8 2010 Owner's Manual

Knowing Your Mazda
Advanced Keyless Entry and Start System
Operation Using Advanced
Key Functions
qKeyless Entry System
This system uses the more traditional
keyless entry buttons to remotely lock and
unlock the doors and opens the trunk lid,
and opens the power windows.
It can also help you signal for attention.
Press the buttons slowly and carefully.
NOTE
The keyless entry system is designed to
l
operate up to about 2.5 m (8 ft) from the
center of the vehicle, but this may vary due
to local conditions.
The system does not operate when the
l
auxiliary key is in the ignition switch.
With the start knob installed in the LOCK
l
position, the system is fully operational. If
the ignition switch is not in the LOCK
position or the start knob is pushed in, the
system does not operate.
All doors cannot be locked by pressing the
l
lock button while any door is open. The
hazard warning lights will also not flash.
If the transmitter does not operate when
l
pressing a button or the operational range
becomes too small, the battery may be
dead. To install a new battery, refer to
Maintenance (page 3-5).
3-14
Transmitter
Operation indicator light
Lock button
Unlock button
NOTE
(U.S.A.)
l
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.
(CANADA)
l
This device complies with RSS-210 of
Industry CANADA. Operation is subject to
the following two conditions: (1) this device
may not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
NOTE
The unlock button can be used to open the
power windows. Refer to Opening the Power
Windows from Outside (page 3-40).
The operation indicator light flashes when
the buttons are pressed.
Lock button
To lock the doors, press the lock button. A
beep sound will be heard once and the
hazard warning lights will flash once.
Panic button
Trunk button