Mazda speed 6 2007 Manual page 75

qAdvanced Key Maintenance
CAUTION
Make sure the battery is installed
l
with the correct pole facing upward.
Battery leakage could occur if it is
not installed correctly.
When replacing the battery, be
l
careful not to bend the electrical
terminals or get oil on them. Also be
careful not to get dirt in the
transmitter as it could be damaged.
There is the danger of explosion if
l
the battery is not correctly replaced.
Replace only with the same type
l
battery (CR2025 or equivalent).
Dispose of used batteries according
l
to the following instructions.
Insulate the plus and minus
l
terminals of the battery using
cellophane or equivalent tape.
Never disassemble.
l
Never throw the battery into fire
l
or water.
Never deform or crush.
l
The following conditions indicate that the
battery power is low:
The KEY indicator light (green) flashes
l
in the instrument cluster when the
engine is turned off.
The system does not operate and the
l
operation indicator light does not flash
when the buttons are pressed.
The system's operational range is
l
reduced.
Advanced Keyless Entry and Start System
Replacing the battery at an Authorized
Mazda Dealer is recommended to prevent
damage to the advanced key. If replacing
the battery by yourself, follow the
instruction below.
Replacing the advanced key battery
1. Pull out the auxiliary key.
2. Release the cap using a flathead
screwdriver, then rotate and remove the
cap.
CAUTION
Do not turn the cap excessively. The
cap may be damaged.
Knowing Your Mazda
Cap
3-5