Table of Contents
Advertisement
First steps
Opening the battery cover
Push downward to open the cover.
Initial charging and discharging of
batteries
If the handset is activated, the flashing bat-
tery icon in the top right of the display indi-
cates that the batteries are being charged.
During handset operation, the battery icon
indicates the charge status of the batteries .
The correct charge level can only be dis-
played if the batteries are first fully charged
and discharged.
¤
To do this, leave the handset in the charg-
ing cradle without interruption for 15
hours.
¤
Afterwards, remove the handset from the
charging cradle and do not put it back
again until the batteries are fully dis-
charged.
Please note:
After the first battery charge and discharge you
may replace your handset in its charger after
every call.
Please note:
u
Always repeat the charging and discharg-
ing procedure if you remove the batteries
from the handset and reinsert them.
u
The batteries may warm up during charg-
ing. This is not dangerous.
u
After a while the charge capacity of the
batteries will decrease for technical rea-
sons.
Registering handsets
You can register up to four handsets to your
base.
Registering the handset to the base station
occurs automatically on first using.
If the automatic register failed, please do the
operations on the handset and on the base
as below.
8
Operations on the handset
é
¤
Press
.
¤
ADVANCED SET.
ê
Select
firm with
.
¤
REGISTRATION
ê
Select
.
¤
Confirm both messages with
¤
Proceed with the operations on the base.
Operations on the base
¤
Press and hold the paging key
the base until beep sounds (approx. 3
sec.).
¤
ê
Input the handset name and confirm
with
.
Once it has been registered successfully, the
handset returns to idle status. The name and
the handset's internal number is shown in
INT
1.
the display e.g.
If fail to register, repeat the procedure.
Deregistering handsets
Please note:
Do not deregister handsets unless necessary!
é
¤
Press
.
¤
ADVANCED SET.
ê
Select
firm with
.
¤
ê
DEREGISTRATION
Select
with
.
¤
Confirm the message with
¤
DEREGISTERED
is displayed.
Handset will ask for registering after deregis-
tered, otherwise you will not able to dial by
handset.
with q and con-
and confirm with
ê
.
÷
ç
(
) on
with q and con-
and confirm
ê
.
Advertisement
Table of Contents
