Table of Contents
Advertisement
WARNING:
pentoxide, or an alkaline battery pack. A risk of fire and burns exists if the battery pack is not
properly handled. To reduce the risk of personal injury:
Do not attempt to recharge the battery.
•
•
Do not expose the battery to temperatures higher than 70°C (158°F).
Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
•
Replace only with the spare designated for this product.
•
IMPORTANT:
configuration. After replacing the battery, reconfigure the system through RBSU.
To remove the component:
Power down the server blade (on page 23).
1.
Remove the server blade (on page 24).
2.
Place the server blade on a flat, level work surface.
3.
Remove the access panel
4.
Locate the battery on the system board
5.
Remove the battery.
6.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
Heatsink
WARNING:
internal system components to cool before touching them.
To remove the component:
Power down the server blade (on page 23).
1.
The computer contains an internal lithium manganese dioxide, a vanadium
Replacing the system board battery resets the system ROM to its default
("Access
panel" on page 26).
("System board
To reduce the risk of personal injury from hot surfaces, allow the drives and the
components" on page 66).
Removal and replacement procedures 41
Advertisement
Table of Contents
