Table of Contents
Advertisement
Slide the access panel towards the rear of the server blade, and then lift to remove the panel.
4.
To replace the component:
Place the access panel on top of the server blade.
1.
Slide the access panel forward until it clicks into place.
2.
Drive blank
Remove the component as indicated.
To replace the component, squeeze the release latch and slide the drive blank into the bay until it clicks into
place.
Drive
To remove the component:
Determine the status of the drive from the drive LED definitions
1.
65).
Back up all server blade data on the drive.
2.
Remove the drive.
3.
To replace the component:
CAUTION:
or the enclosure unless all drive and device bays are populated with either a component or a
blank.
To prevent improper cooling and thermal damage, do not operate the server blade
("Hot-plug drive LED
definitions" on page
Removal and replacement procedures 27
Advertisement
Table of Contents
