Table of Contents
Advertisement
Remove the processor from the processor retaining bracket.
18.
Install the processor socket protective cover in each processor socket.
19.
Retain all of the information on the serial label pull tab for use in installing the new system board.
20.
Remove the enclosure connector covers from the new system board and install the enclosure connector
21.
covers on the damaged system board
To replace the system board:
Place the new server blade system board with base pan on a flat level surface.
1.
IMPORTANT:
board.
If the server blade had less than four processors installed, install a heatsink blank each of the remaining
2.
processor sockets.
("Enclosure connector
Install all components in the same configuration prior to removing the system
("Heatsink
blank" on page 34)
covers" on page 28).
Removal and replacement procedures 50
Advertisement
Table of Contents
