1.3 Camera Feature Locations
1.3.1 Front View
Power Indicator
During normal operation Power Indicator will be turned on in the default.
Blinking will occur during the following situation.
•
During the lens centre positioning after turning on the power.
•
During the Update Firmware.
•
During initializing after pushing CLEAR SETTING button.
•
During getting the IP address from the DHCP server.
•
Because of the breakdown of the Network Camera. Please refer to Section
4.4 Troubleshooting.
Fixed Focus Lens and Pan/Tilt operation
Fixed Focus Lens can move in the Pan/Tilt operation. Operation Bar on the Single
Camera screen can operate the Pan/Tilt. The Pan/Tilt moves the lens horizontally
120° and downside 45°. Please refer to Page 39 for the Operation Bar.
Notes
•
Do not force to move the lens part around the Fixed Focus Lens.
Compulsive touching may damage the Pan/Tilt motor.
•
Do not touch the Fixed Focus Lens. It may leave a finger print and can
cause the image to be out of focus. This can also take away the
protective coating on the Fixed Focus Lens.
12
Power Indicator
(Refer to Page 72 for the Setup.)
Fixed Focus Lens
1 m—Infinity
Pan: - 60° to + 60°
Tilt: 0° to - 45°
Operating Instructions