Upgrading The Flash - Multitech MultiConnect Adapter Serial-to-Ethernet Adapter with IP User Manual

Upgrading the Flash

Serial Flash Upgrade
The following steps explain the procedure to upgrade a flash using the serial COM port (serial flash upgrade).
Connect the Adapter to a PC COM Port.
•
Open an application through which we can access the serial device(e.g., Meterm, zoc, hyperterm).
•
Reboot the Adapter.
•
Wait for the boot message and prompt "press d to download" to appear.
•
Press d when prompted.
•
Select the XMODEM Protocol from the Terminal application.
•
Choose a file (MTXCSEM-TFTP-...) file to be uploaded.
•
Perform a file upload.
The Adapter reboots and will be up after a few seconds (10-15 secs).
Ethernet Flash Upgrade
The Adapter can be remotely upgraded over a network. Make sure a TFTP client is already installed on the
machine.
The following steps explain the method to perform flash upgrade from Ethernet.
•
Make sure the Adapter is reachable on the LAN.
•
Perform a TFTP to the Adapter from a TFTP client.
– Set binary mode on
– Binary
•
Put the binary file.
– put <binary filename>
•
Exit the TFTP session.
– quit
The Adapter reboots after it has been successfully upgraded.
Multi-Tech Systems, Inc. MultiConnect Serial-to-Ethernet Adapter User Guide (S000344D)
(Note: This step is very important)
Chapter 6 – Upgrading the Firmware and Flash
18