Table of Contents
Advertisement
Chapter 2 – Installation and Cabling
Step 1 – Attaching the Adapter to a Fixed
Location
The Serial-to-Bluetooth Adapter is design to be used on the desktop or to be panel-mounted. To attach the bracket
for panel-mounting, following these steps:
1.
Typically, the adapter is mounted against a flat surface with two mounting screws. Drill the mounting holes at the
desired location. The mounting holes must be separated by 4 -7/16 inches center-to-center.
2.
Slide the mounting bracket into the slot on the back of the chassis.
3.
Attach the adapter to the surface with two screws.
Multi-Tech Systems, Inc. Serial-to-Bluetooth Adapter User Guide (S000370A)
Chapter 3 – AT Commands, S-Registers, and Result Codes
9
Advertisement
Table of Contents
