Advertisement
Quick Links
The Liebert GXT3 is shipped with the following items:
•
Terminal Block Communication terminals
•
Compact disc with:
o
Liebert MultiLink®
o
Configuration program
o
User manual (electronic version)
•
USB cable, one; 2m (6-1/2 ft.) long
•
Rack handles with mounting hardware
•
Basic Power Output Distribution (POD), installed on Liebert GXT3
•
Plastic tower support base, one set
•
Plastic Bezel
•
Warnings, safety instructions booklet and WEEE recycling sheet (ISO 14001 compliance)
If the UPS is intended to be installed in the Tower orientation, locate the support base and spacers then assemble the two
stand assemblies with an even number of spacers in each assembly. Insert the UPS between the support base
assemblies with adequate space between the assemblies as shown in the picture below. Note the display should be
located on the upper half of the unit in the Tower orientation. To rotate the display with the bezels removed, depress the
grooved tabs on the sides and rotate it 90 degrees clockwise. If the USP is to be installed in a rack enclosure, follow the
instructions provided with the rack mounting hardware for proper installation.
If using an optional POD that was purchased separately, please see instructions shipped with the new POD to remove the
standard POD and install the new POD. This should be done before connecting the UPS to utility power.
Conduit entry knockout are provided if the hardwired PODs are being used. Input and output wiring should be installed in
separate conduits. All wiring should be done in accordance to all local and national electrical codes. Before wiring the
UPS ensure that the breaker in the external upstream panelboard is OFF.
UPS Model
GXT3-5000RT208
GXT3-6000RT208
Terminal Block Connections
Quick Start Guide – 5000-6000VA RT208 Models
Recommended
(Maximum) External
Over Current
Protection
30A
L2
N
OUTPUT
™
®
Liebert
GXT3
Recommended Wire
(All wires)
75 degC Copper Wire
2
10 AWG (4mm
)
L1
L2
1
Maximum Wire
Accepted by
Terminal Block
2
8 AWG (6mm
)
N
L1
INPUT
SL-23185QS6_Rev0_09-2012
Terminal Block
Torque
10 in-lb
Advertisement
Related Manuals for Liebert GXT3-5000RT208
Summary of Contents for Liebert GXT3-5000RT208
- Page 1 ™ ® Liebert GXT3 Quick Start Guide – 5000-6000VA RT208 Models The Liebert GXT3 is shipped with the following items: • Terminal Block Communication terminals • Compact disc with: Liebert MultiLink® Configuration program User manual (electronic version) • USB cable, one; 2m (6-1/2 ft.) long •...
- Page 2 If an optional POD with attached input cord and output receptacles are used, connect the input to a L14-30 receptacle and connect the user supplied equipment to the output receptacles. ™ ® The Liebert GXT3 5000-6000 VA models ship without the internal battery installed. Locate the internal battery kit, model number GXT3-144BATKIT, and follow these steps to install the battery.
- Page 3 LEDs to illuminate. 6. The Liebert GXT3 UPS has customizable settings that might be required depending on the application. Please review the CD that ships with the UPS unit for the steps to use the configuration program and make any necessary changes.
-
Page 4: Troubleshooting
Bypass feedback (1-second beep every 4 seconds) B&C REPO (one quarter-second beep at quarter-second intervals) B&E Short circuit on the output ® UPS shutdown by command from communication (USB or Liebert IntelliSlot port) C&E (no audible alarm) AC Input Indicator L-N reverse...