Advertisement
If an optional POD with attached input cord and output receptacles are used, connect the input to a L14-30 receptacle and
connect the user supplied equipment to the output receptacles.
™
®
The Liebert
GXT3
5000-6000 VA models ship without the internal battery installed. Locate the internal battery kit,
model number GXT3-144BATKIT, and follow these steps to install the battery.
1. Remove the screws on the battery door and remove the battery door. Set aside the screws and door for
reassembly.
2. Insert the two battery trays and connect the plugs to the mating receptacles
3. Gently push the battery wiring into the compartment making sure that the wiring will not be pinched when the
battery door is reinstalled.
4. Reinstall the battery door and secure using the screws that were removed in step 1.
5. Locate the plastic bezel from the shipping box and attach the bezels to the UPS taking care to align the fastening
clips on both ends before inserting them into the holes.
6. If your application requires the use of external battery cabinets for longer back up time requirements, connect the
first battery cabinet to the UPS with the cable provided with the battery cabinet. Note: Either connector is
acceptable to connect the external battery cabinet. If more than one battery cabinet is used the additional
cabinets then connect to the previously connected battery cabinet.
GXT3-144BATKIT
2
SL-23185QS6_Rev0_09-2012
Advertisement
