Extended "AT%" (Percent) Command Set (* indicates factory default setting)
Command Function
%B
%C0
%C1 *
*
Extended "AT-" (Dash) Command Set (* indicates factory default setting)
Command Function
-Cn
-C0 *
-C1
MT5634ZLX/E
Chapter 3 - AT Commands, S-Registers, and Result Codes
View numbers in blacklist. If blacklisting is in effect, this command displays the
numbers for which the last call attempted in the past two hours failed. The ERROR
result code appears in the countries that do not require blacklisting. %Cn Data
compression control
No data compression
V.42bis/MNP 5 data compression enabled.
Data calling tone options
Disable data calling tone
Enable data calling tone (the freq. is 1,300 Hz with a cadance of 0.5 sec. ON and 2
sec. OFF)
39