General Specifications - Gigaset S820 User Manual

Information about the USB port
u
The handset's battery is charged using a USB connection with a power supply of 500 mA.
u
On USB connections with lower charging currents, the consumption of the handset itself
may be greater than the recharging. In this case the battery charge decreases.
Base power consumption
In standby mode
- Handset in charger
- Handset outside charger
During a call

General specifications

DECT
DECT standard
GAP standard
No. of channels
Radio frequency range
Duplex method
Repeat frequency of the transmission pulse
Length of the transmission pulse
Channel grid
Bit rate
Modulation
Language code
Transmission power
Range
Base power supply
Ambient conditions for operation
Dialling mode
Bluetooth
Radio frequency range
Transmission power
Pin connections on
the telephone jack
S820 S820A
 
Approx. 1.2 W Approx. 1.2 W
Approx. 0.55 W Approx. 0.65 W
Approx. 0.65 W Approx. 0.75 W
Supported
Supported
60 duplex channels
1880-1900 MHz
Time division multiplexing, 10 ms frame length
100 Hz
370 μs
1728 kHz
1152 kbit/s
GFSK
32 kbit/s
10 mW average power per channel, 250 mW pulse power
Up to 50 m in buildings, up to 300 m outdoors
230 V ~/50 Hz
+5°C to +45°C, 20% to 75% relative humidity
DTMF (tone dialling)/PD (pulse dialling)
2402-2480 MHz
4 mW pulse power
3
2
1
4
1 unused
5
2 unused
3 a
6
4 b
5 unused
6 unused
Appendix
71