Table of Contents
Advertisement
1.10 MT2834MR6 Installation Notes
All installation must be done by a qualified service person.
The installation instructions in your MultiModemManager Owner's Manual include information about the use
of blanking plates to cover empty slots in the card frame. Be sure to follow those instructions.
Warning: Interconnection directly, or by way of other apparatus, of ports marked "SAFETY WARNING see
instructions for use" with ports marked or not so marked may produce hazardous conditions on the network.
Advice should be obtained from a competent engineer before such a connection is made.
This product is intended to be hard wired to the network. The final connection to the network is the
responsibility of the public telecommunications network operator or a person authorized by that operator.
Any other apparatus, including cable and wiring, connected between the MT2834MR6K modem and the
point of connection to any speechband circuit shall comply with the following:
1.
The overall characteristics of this apparatus shall be such as to introduce no material effect upon the
electrical conditions presented to one another by the modem and he speechband circuit.
2.
The apparatus shall comprise only
a.
apparatus approved for the purpose of connection between the modem and a speechband
circuit; and
b.
cable and wiring complying with a code of practice for the installation of equipment covered by
this part of BS 6328 or such other requirements as may be applicable.
Note: Such apparatus may have been approved subject to limitations in its use.
1.11 Safety Warnings
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in wet locations unless the jacks are specifically designed for wet locations.
•
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at
the network interface.
•
Use caution when installing or modifying telephone lines.
•
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electrical shock from lightning.
•
Do not use the telephone to report a gas leak in the vicinity of the leak
•
Ports that are connected to other apparatus are defined as SELV. To ensure conformity to EN 41003,
ensure that these ports are only connected to the same type on the other apparatus.
Chapter 1 - Introduction
16
Advertisement
Table of Contents
