Multitech MultiModem MT2834MR6 User Manual page 99

Multi-tech systems user guide multimodem mt2834mr6
Hide thumbs Also See for MultiModem MT2834MR6:
Table of Contents

Advertisement

&CDn
n = 0 or 1
Ds
s = phone #
DsNd
s = phone #
d = 0 or 1
&Dn
n = 0, 1, 2,
or 3
%DCn
n = 0 or 1
%DFn
n = 0 or 1
%DPn
n = 0 or 1
>DTn
n = 0 or 1
En
n = 0 or 1
Cleardown at Disconnect
*** &CD0 Enable cleardown.
&CD1 Disable cleardown.
Dial
Dial telephone number s , where s may include up to 60 digits or T, P, R, comma,
colon, and semicolon characters.
Store Phone Number
To store, enter D followed by telephone number s , then N followed by directory
number d .
Data Terminal Ready Control
&D0
Modem ignores DTR signal.
&D1
When DTR drops, the modem hangs up. While DTR is low, the modem accepts
commands but will not dial or auto-answer until DTR goes high again.
Same as &D1 .
*** &D2
&D3
When DTR drops, the modem hangs up and resets as if an ATZ or an AT&F
command was issued.
Command Mode Control
*** %DC0 Enable command mode.
%DC1 Disable command mode.
Line Probe Data Format
*** %DF0 V.34 line probe data displayed in graph format.
%DF1 V.34 line probe data displayed in table format.
Line Probe Data Read
*** %DP0 Disable reading of line probe data during the V.34 handshake.
%DP1 Enable reading of line probe data during the V.34 handshake.
DTMF Detection
*** >DT0 Disable DTMF detection.
>DT1 Enable DTMF detection when off-hook.
Echo Command Mode Characters
E0
Do not echo command mode characters.
*** E1
Do echo command mode characters.
Appendix
99

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MultiModem MT2834MR6 and is the answer not in the manual?

Questions and answers

Table of Contents