Multitech MultiModem MT2834MR6 User Manual page 33

Table 3-2. Where the Modem Reads Configuration Parameters
Previous Command
AT&W1 (default)
AT&W0
AT&F8&W0
AT&F9&W0
Z Reset Modem
The Z command resets the modem to its default configuration and clears the command
buffer. The result is the same as turning the modem off and on. When you type ATZ, the
state of the &W command determines where the default values originate. &W0 defaults
come from the customized configuration in NVRAM, and &W1 defaults come from the
factory default configuration in ROM. Because Z clears the command buffer, it must be the
last command in a command string; normally it is issued by itself: ATZ.
Note that the Z reset command operates differently from the &F reset command. See Table
3-2.
Power-On
AT&F and ATZ
ROM ROM
ROM NVRAM
ROM NVRAM
NVRAM NVRAM
Chapter 3 - AT Commands
33