Sony MEX-BT5100 Service Manual page 26

MEX-BT5100
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• Y : Parts extracted from the conductor side.
• : Internal component.
f
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Parts face side: Parts on the parts face side seen from
(Conductor Side) the pattern face are indicated.
Pattern face side: Parts on the pattern face side seen from
(Component Side) the parts face are indicated.
Caution:
Parts face side: Parts on the parts face side seen from
(SIDE A) the pattern face are indicated.
Pattern face side: Parts on the pattern face side seen from
(SIDE B) the parts face are indicated.
MEX-BT5100
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specifi ed.
• : internal component.
f
• C : panel designation.
Note: Note:
The components identi- Les composants identifi és
fi ed by mark 0 or dotted par une marque 0 sont
line with mark 0 are criti- critiques pour la sécurité.
cal for safety. Ne les remplacer que par
Replace only with part une piéce portant le nu-
number specifi ed. méro spécifi é.
• A : B+ Line.
• Power voltages is dc 14.4V and fed with regulated dc
power supply from ACC and BATT cords.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
– SERVO Board –
no mark : CD PLAY
– Other boards –
no mark : TUNER (FM/AM)
( ) : CD PLAY
* : Impossible to measure
• Voltages are taken with a VOM (Input impedance 10
MΩ).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
: AUDIO
F
f : TUNER
: CD PLAY
J
p : BLUETOOTH OUT
l : BLUETOOTH IN
: MIC
N
: AUX IN
E
• Abbreviation
CND : Canadian model
26
• Circuit Boards Location
SENSOR board
IT board
ANTENNA board
KEY board
26
SERVO board
TUNER UNIT
(TUX401)
MAIN board
SUB board