Table of Contents
Advertisement
F E AT U R E S - O P E R AT I O N S
ASSEMBLY
The heater is packaged with the feet unattached. You must
attach them before operating the heater.
CAUTION: Do not operate this heater
without casters attached.
WARNING: Do not operate without feet
attached. Do operate the heater only in
upright position (feet on the bottom, controls
on the top), any other position could create
a hazardous situation.
ASSEMBLY INSTRUCTIONS:
• Unpack the heater and remove all parts from the
packaging.
• For ease of assembly, place the heater upside down or
on its side on a soft surface which will not scratch the
unit. Use one hand to hold it in place.
• Place the bowlegged castor-mounting plate in the front
and put straight castor-mounting plate in the end.
• Screw off the wing nuts from the U-shaped bolt provided,
attach the U-shaped bolt to the U-facing flange between
first and second fins (near the front cover).
• To attach the castor mounting plate to the radiator body,
you should insert the ends of the U bolt in the holes on
the castor mounting plate.
• Screw the wing nuts back to the U bolt and fasten the
wing nut properly.
LOCATION OF THE HEATER:
1. Turn the heater upright. Ensure legs are correctly
installed and level.
2. Place heater on a flat and stable surface. Setting the
heater on an incline or decline may cause damage to the
unit and create a hazardous situation.
CAUTION: Operate the heater in upright position only.
Any other position could create a hazardous situation.
CAUTION: Ensure that the surface beneath the
heater is clean and free of any obstructions. It is
not recommended that this heater be placed on
high pile carpeting or any other surface that
impedes the flow of air underneath the heater.
Figure A
A. Digital display
B. Power light
C. Mode button
D. Power switch
E. Reduce button
F. Add button
G. Timer light
1
Number of Hours(Timer)
1
PDF !"#
"pdfFactory Pro" $#%&'(
Heater Level Setting
3
2
3
Set temperature
2
www.fineprint.cn
ECO Mode
4
4
Advertisement
Table of Contents
