Zanussi ZDF26001WA User Manual
Hide thumbs Also See for ZDF26001WA:


User Manual
EN User Manual


Table of Contents

Summary of Contents for Zanussi ZDF26001WA

  • Page 1 User Manual GETTING STARTED? EASY. ZDF26001WA ZDF26001XA EN User Manual Dishwasher...
  • Page 2: Safety Information

    SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. CHILDREN AND VULNERABLE PEOPLE SAFETY This appliance can be used by children aged from 8 years and •...
  • Page 3: Safety Instructions

    Do not keep the appliance door open without supervision to • prevent to fall on it. Before maintenance, deactivate the appliance and disconnect • the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. •...
  • Page 4 DISPOSAL WARNING! Risk of injury or suffocation. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. • Remove the door catch to prevent children and pets to get closed in the appliance.
  • Page 5: Control Panel

    CONTROL PANEL On/off button Delay button Display Programme buttons Indicators INDICATORS Indicator Description Multitab indicator. Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates.
  • Page 6: Consumption Values

    PROGRAMMES Consumption values Degree of soil Programme Programme phases Type of load Duration Energy Water (min) (kWh) Normal soil • Prewash 1.050 Crockery and • Wash 50 °C cutlery • Rinses • • Prewash 40 - 150 0.6 - 1.4 7 - 12 Crockery, cut- •...
  • Page 7: Programme Selection Mode

    SETTINGS PROGRAMME SELECTION MODE The appliance is in programme selection mode when after the activation all the programme indicators come on and the display shows two horizontal status bars. When the appliance is in programme selection mode it is possible to set a programme. If the control panel does not show this condition, do the Reset.
  • Page 8: The Water Hardness Table

    THE WATER HARDNESS TABLE German degrees French degrees Water softener mmol/l Clarke degrees (°dH) (°fH) level 47 -50 84 - 90 8.4 - 9.0 58 - 63 43 - 46 76 - 83 7.6 - 8.3 53 - 57 37 - 42 65 - 75 6.5 - 7.5 46 - 52...
  • Page 9: Deactivating The Rinse Aid Dispenser

    DEACTIVATING THE RINSE AID DISPENSER While the appliance is in user mode: 1. Press • The indicators are off. • The indicator continues to flash. • The display shows the current setting: – = rinse aid dispenser activated. – = rinse aid dispenser deactivated. 2.
  • Page 10: Daily Use

    ADDING RINSE AID The rinse aid helps to dry the dishes without streaks and stains. It is automatically released during the hot rinse phase. DAILY USE 1. Open the water tap. 3. Load the baskets. 2. Press the on/off button to activate the 4.
  • Page 11: Starting A Programme

    The function comes into operation: • 5 minutes after the completion of the programme. • After 5 minutes if the programme has not started. STARTING A PROGRAMME The programme starts. The programme duration starts to decrease with steps of 1 minute. OPTION DELAY max.
  • Page 12: Hints And Tips

    Activate or deactivate the Multitab option before the start of the programme. Activate Multitab option only when you use the combi detergent tablets. This option deactivates the release of salt. The salt indicator does not come on. The programme duration can increase. This option in not applicable to OPENING THE DOOR WHILE THE APPLIANCE OPERATES If you open the door while a programme is running, the appliance stops.
  • Page 13: Unloading The Baskets

    LOADING THE BASKETS The water softener should be adjusted according to the hardness of the water in your area. Your local • Only use the appliance to wash items that are water authority can advise you on the hardness of dishwasher-safe.
  • Page 14: Troubleshooting

    CLEANING THE FILTERS • Make sure that there are no residues of food or soil in or around the edge of the sump. • Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides. •...
  • Page 15: The Washing And Drying Results Are Not Satisfactory

    Problem and alarm code Possible solution You cannot activate the appli- • Make sure that the mains plug is connected to the mains sock- ance. • Make sure that there is no damaged fuse in the fuse box. The programme does not start. •...
  • Page 16: Technical Information

    TECHNICAL INFORMATION Dimensions Width / height / depth (mm) 600 / 850 / 625 Voltage (V) 220 - 240 Electrical connection Frequency (Hz) Water supply pressure Min. / max. bar (MPa) 0.5 (0.05) / 8 (0.8) Water supply max 60 °C Cold water or hot water Capacity Place settings...

This manual is also suitable for:


Table of Contents