Replacing Parts; Assembling The Oximeter - GE TuffSat User's Manual And Service Manual

TuffSat User's Guide and Service Manual

Replacing parts

You can replace any part listed below with a new part as you assemble the
oximeter:
•
•
•
•
•
•
•

Assembling the oximeter

1.
2.
3.
4.
5.
6.
7.
8.
3-6
Front case (with installed lens, lens gasket, and IR window)
Button cover
Bumper
Sensor connector assembly
Circuit board
Back case (with blank label)
Battery door
Position the button cover over the small posts in the front case and press it into
place.
Align the hole in the bumper with the IR window in the front case. Wrap the
bumper around the case, aligning the slots. Slide the bumper onto the case.
Connect the sensor connector assembly cable to the circuit board:
Grasp the cable near its connector and align its connector with the connector
on the circuit board.
Gently (but firmly) slide the cable into the circuit board connector until it is
firmly seated.
Position the circuit board in the front case. Carefully bend the cable to position
the sensor connector over its slot in the case. Slide it into the slot. Adjust the
bumper around the sensor connector to ensure a snug fit.
Align the notches on the back case with the bumper. Be sure that the 2 battery
contacts on the circuit board slip into the 2 slots in the battery compartment.
Press down on the case, working your way around the unit.
When the back case is pressed firmly against the front case, install the 3 screws
that secure the back case to the front case.
NOTE: If you installed a new back case, remove the old label or write the
information it contains on the blank label. Attach the label to the new back
case.
Install the batteries and battery door:
Align the + on each battery with the + shown inside the battery compartment.
Position the battery door hinges in the slots on the back case, close the door,
and tighten the screw that secures it to the unit.
Complete the Checking normal operation procedure in chapter 2.