Printer Components; Using The Printer; Powering The Printer - GE TuffSat User's Manual And Service Manual

TuffSat User's Guide and Service Manual

Printer components

Using the printer

Powering the printer

WARNING: Fire/explosion hazard. Do not use the printer in the presence of any
flammable anesthetic mixture.
CAUTION: To avoid damage to the printer, use only an AC adapter recommended by
and available from Datex-Ohmeda.
CAUTION: Connect the adapter to a proper power source according to the voltage
and grounding requirements found on the product case. Unplug it from the power
source when it is not in use.
1.
2.
3.
A-2
Power I/O (on/off) switch
Slide right to power on the printer; slide left to power it off.
Power-on indicator
Illuminates red when the printer is on.
Infrared link receiver
Receives data to be printed from the oximeter's infrared link transmitter.
Before you begin, check the following:
• The printer has paper.
• Four 1.5V alkaline AA batteries are installed in the printer.
If you are using the AC adapter, verify that it is the correct adapter for your
local line voltage. Then, connect the adapter:
• Plug the AC adapter into the port on the back of the printer (left of the paper
roll door).
• Connect the adapter to the AC mains power supply.
To power on the printer, move the | /
Paper feed slot
Paper feeds out from the printer through this slot. Use the
top edge of the plastic slot cover to tear off the paper.
Paper advance button
Press to feed paper from the roll through
the slot and to advance the paper when
printing is complete.
Contrast selector
Slide left for low contrast; slide right for high
contrast.
O slider to the right—the | (on) position.