Time Display Mode; Alarm Function; Specifications - Oregon Scientific RMR183 User Manual

TIME DISPLAY MODE

When the display is in calendar mode, press [MODE] once to
change between the hour, minute, seconds display to hour, minute,
Day-of-Week display.
Hour-Minute-Second
HOW TO SET AND ACTIVATE
THE ALARM
While in alarm mode, press and hold [ALARM] for two seconds
the hour digits will flash.
Enter the value for the hour digits. Press [ALARM] to confirm and
go to the minute digits. Enter the value and press [ALARM] to
confirm.
The alarm is automatically activated. To deactivate it, press
[ALARM] once.

ALARM FUNCTION

When the alarm is active, it will go off at the set time with the
ALARM ON icon flashing.
The crescendo function allows the alarm to start off gently and
step up its intensity in three steps. Without interruption, the
alarm will go off for a minute and will go off once again after
approx. 8 minutes.
Hour-Minute-Day
9
To stop the alarm, press any key (except [MEMORY] and
[CHANNEL] ) .
PRECAUTIONS
This product is engineered to give you years of satisfactory service
if you handle it carefully. Here are a few precautions:
1. Do not immerse the unit in water.
2. Do not clean the unit with abrasive or corrosive materials. They
may scratch the plastic parts and corrode the electronic circuit.
3. Do not subject the unit to excessive force, shock, dust,
temperature or humidity, which may result in malfunction,
shorter electronic life span, damaged battery and distorted
parts.
4. Do not tamper with the unit's internal components. Doing so will
invalidate the warranty on the unit and may cause unnecessary
damage. The unit contains no user-serviceable parts.
5. Only use fresh batteries as specified in the user's manual. Do not
mix new and old batteries as the old ones may leak.
6. Always read the user's manual thoroughly before operating the
unit.

SPECIFICATIONS

Temperature Measurement
Main unit
Indoor Temperature measurement
Operating range : -5.0°C to +50.0°C
(23.0°F to 122.0°F)