Preparing The Scale; Fitting The Display Pole And Setting Up The Scale - ISHIDA iwq-150/30 Operation Manual

The following describes the procedure for preparing the scale before operation.

3-1 Fitting the Display Pole and Setting Up the Scale

The display unit and display pole are fitted together with a tightening knob. The display pole
and the bracket pipe base are separated.
1. Remove the Bracket Pipe.
Remove the bracket pipe from the bracket pipe base (by loosening the four hex head
screws).
2. Pass the Load Cell Cable through the Display Pole.
Push the extra length of cable protruding from the bracket pipe base into the display pole.
3. Stand the Display Pole against the Bracket Pipe Base.
Stand the display pole against the bracket pipe base by fitting it at its load cell cable side into
the tongue of the bracket pipe base.
Manual No. 0142A

3. Preparing the Scale

Do not pull strongly on the load cell cable
when pushing it into the display pole. Other-
wise, it may be cut.
If the cable covering material is scratched,
water may penetrate into the cable and cause
unreliable weighing, or the core material may
corrode and cause the scale to fail.
IWQ Operation Manual Kg Version 9