Advertisement
F
T
IRES OF
RADITION
Carefully set one of the side slips of the
4 pc inner frame kit into position, by
sliding it behind the inner edge of the
leg, and into the slot in the bottom riser.
Note the edges that it comes in contact
with. Remove the slip, apply a thin bead
of cement along these edges, and set the
slip back into position. Wipe off any
extra cement with a wet cloth.
Step #13
I
I
NSTALL
NSTRUCTIONS FOR
leg.
plied in the blister pack, and carefully
insert it between the block on the inside
top of the leg and the bracket. This will
help hold the leg against the wall. There
is a place for a second shim at the bot-
tom of the legs if required. Installing the
second shim may be done by reaching in
from the front bottom of the leg. This is
only necessary where the wall is ex-
tremely out of vertical. Please use your
own discretion in placing the second
shim.
Step #11
damage can occur! Make sure that the
beam is properly seated onto the top of
leg before letting go of it, as any
dropping of the beam against the top of
the legs can cause chipping.
position, apply a bead of cement on the
top edges of the legs, and along the two
back sides of the beam, and carefully
lower into position. Hold the beam away
from the back wall as it is lowered into
position, so as not to mark the wall.
P
9
AGE
OF
J
T
URASTONE
ORRANCE
This image is looking down inside the
Take one of the wooden
Step #12
Note; The next step is frequently where
Once both, left and right slips are in
18
#4004
shims sup-
Advertisement
