Advertisement
F
T
IRES OF
RADITION
Important!! When setting the mantel pieces into position that have cement on them,
be very careful that you set the pc down into its final position. Avoid moving the pc
around, and spreading the cement beyond it's intended final resting position. If this
does happen, wipe it off immediately with a clean, damp cloth. Use sufficient pres-
sure when doing so to insure that the cloth picks up all of the residue of the grout.
Because of the textured surface, it is very easy for some grout to remain on the
surface, which is not visible until after the installer leaves, and it has dried. A soft
brush is very helpful in cleaning the surface to remove this residue completely.
If not completely cleaned, a cloudy haze can show. Once this haze has formed from
the grout drying on an exposed surface, it is very difficult to remove with water.
However, a commercial grout and haze remover, [such as 'Tile Lab'- a product
Step #9
This image is looking down inside the
leg.
Take one of the wooden
plied in the blister pack, and carefully
insert it between the block on the inside
top of the leg and the bracket. This will
help hold the leg against the wall. There
is a place for a second shim at the bot-
tom of the legs if required. Installing the
second shim may be done by reaching in
from the front bottom of the leg. This is
only necessary where the wall is ex-
tremely out of vertical- use your own dis-
cretion in placing the second shim.
I
I
NSTALL
NSTRUCTIONS FOR
hearth
position of the foot of each leg. Apply a
thin line of cement along the bottom of
the leg, and along the back edge, where
the leg will meet the wall.
insuring that it is firmly bedded on the
hearth and against the wall. Take extra
care to not get the cement all over the
wall, as this will make the clean-up
much harder.
shims sup-
P
15
AGE
OF
J
T
URASTONE
ORRANCE
There is a light line marked on the
indicating
Carefully lower the leg into position
18
#4004
the
approximate
Step #10
Advertisement
