Advertisement
F
T
IRES OF
mantel can be cleaned off very easily using the white eraser provided. If the mantel
is chipped at any point, it can be touched up with the two piece touchup provided.
Installing the Torrance with the Windsor Front
The front of the Windsor plate must be
installed 2 7/8" away from the wall, in
order to fit against the back of the leg.
Again, it is prudent to do a dry run befor
beginning to install the wall brackets to
insure that the firebox sits in the correct
position relative to the hearth and other
mantel components.
I
I
RADITION
NSTALL
NSTRUCTIONS FOR
Step #17
J
URASTONE
Check the fit of the shelf onto the top of
the beam and bracket, then remove.
Adjust bracket if necessary. Apply a
thin bead of cement along the top edge
of the beam, and against the back edges
of the shelf. Carefully lower the shelf
into position onto the beam. Use a small
wood shim in the joint between the
beam and shelf if necessary to insure
that the top surface of the shelf is
horizontal. Don't forget to apply a small
amount of cement in the holes when the
shims are removed. Carefully wipe all
excess cement off mantel along the
joints with a wet cloth, paying special
attention to our comments on page 8 in
this manual. Any other types of marks
that have occured on the surface of the
If you are going to use the Windsor with
the
530
Fenderfire front with the 534– then you
will not require the 4 pc slip kit. The 530
firebox must be installed so that it is 2"
from the finished floor, and will rest upon
the hearth.
P
11
18
AGE
OF
T
#4004
ORRANCE
firebox,
rather
than
the
Advertisement
