Advertisement
F
T
IRES OF
RADITION
Step #6
Note: The gloves are supplied for the in-
stallers to insure a clean installation.
These help minimize the cleanup required
after the install is complete. Mix up a
small bit of the grout/cement by adding a
small amount of water until you get a
paste like consistency.
Butter the bottom of the hearth with a
thin bead of the cement provided, and
reset the hearth into position. Insure that
the hearth is level. A couple of wood
shims [not supplied for this purpose]
carefully positioned under the hearth can
help keep it level while the cement dries.
Make sure that the any shims used are re-
moved and the holes touched-up with
cement.
Step #8
P
AGE
I
I
NSTALL
NSTRUCTIONS FOR
7
18
OF
J
T
URASTONE
It is very important that sufficient
screws are installed in the brackets and
in the wood to support the whole man-
tel. Failure to insure that these brackets
are firmly secured to the wall risks that
the mantel could fall off the wall, result-
ing in serious injury.
Carefully
slide
position, centering it on the fireplace
(you may find it easer to do this step if
you draw a very small center line on the
top back edge of the hearth). Put a
couple of small pencil marks on the
floor indicating its final position, then
Step #7
The lower piece [riser] of the 4 pc inner
frame [JSUR slip kit] can now be set into
position, and centered on the fireplace.
Apply a thin bead of cement along the
bottom edge of this riser, and carefully
position into position, centering it on the
fireplace.
A small pencil line on either side of the
riser will allow you to easily find the
right place once you have removed and
applied the cement to the bottom. Take
care to make sure that the riser is
pushed all the way back against the wall.
There should be no need to level the
riser seeing as it is placed on a level
hearth.
#4004
ORRANCE
the
hearth
into
Advertisement
