Advertisement
F
T
IRES OF
RADITION
Apply a bead of cement along top edge
of the left and right slip and the inside
edge of the beam, where the fourth piece
of the slip kit comes in contact with the
beam.
Carefully lower the arched top slip be-
hind the beam and into position on top
of the side slips.
Carefully wipe the extra cement off the
joints.
Step #16
Check the fit of the shelf onto the top of the
beam and bracket, then remove. Adjust
bracket if necessary. Apply a thin bead of
cement along the top edge of the beam, and
against the back edges of the shelf. Carefully
lower the shelf into position onto the beam.
Use a small wood shim in the joint between
the beam and shelf if necessary to insure that
the top surface of the shelf is horizontal.
Don't forget to apply a small amount of
cement in the holes when the shims are
removed. Carefully wipe all excess cement
off mantel along the joints with a wet cloth,
paying special attention to our comments on
page 8 in this manual.
I
I
NSTALL
NSTRUCTIONS FOR
Step #15
centered along the top edge of the
horizontal 2x4.
P
17
AGE
OF
J
T
URASTONE
ORRANCE
Install the shorter remaining bracket
Step #16
18
#4004
Step #14
Advertisement
