Burner Setup; Control Panel Layout - Dacor Renaissance RNTT365GB Installation Instructions Manual

Burner Setup

Burner icon Burner setting
(Sear Burner) DOWN button
WARNING
• Make sure that power to the electrical outlet is
turned off at the circuit breaker panel or fuse box
and that the gas is turned off at the gas supply
valve before proceeding.
• The cooktop must be properly grounded at all times
when electrical power is applied.
• Before using the cooktop, carefully read the
accompanying Use and Care Manual.
Before finalizing the burner setup, the electricity and gas
must be configured.
1. Plug the power cord into a grounded outlet.
2. Send power to the outlet. (Switch on power at the
circuit breaker panel or fuse box.)
3. Turn on the gas supply valve.
4. Perform the following ignition test for all of the
burners:
IGNITION TEST
• Touch the ON/OFF button for approximately two
seconds to turn on the cooktop. The lights on the
burner displays are lit when it is ON.
• When the burner lights, it will come on at the
maximum setting (5). When the unit is installed
properly, the flames will be steady. Each will also
have a sharp, blue inner cone that will vary in
length depending on the burner size.
Correct Flame Appearance
Installation Instructions
Burner setting
UP button

Control Panel Layout

Burner Burner
control location
display indicator
Clock button
Clock "—"
DOWN button
Lighting the Burners
Make sure the power is ON. If not, press the
ON / OFF button for 2 seconds to start.
Refer to the below Burner Controls image
below for instructions on burners.
To Light a Burner:
• Select a burner. Touch and
release the "+" button twice
within 3 seconds.
When first lit, each burner
flame begins at the
maximum setting of "5."
• After the burner is lit,
lower the flame by
touching the "—" button.
• The burner control system will make a maximum of 3
attempts at 10-second intervals to light the burner.
• Should the burner fail to light after the third attempt
and "b" appears on the display:
1) Open an outside window and allow the gas to dis-
sipate. After 5 minutes, 2) reset the burners, and 3)
attempt to light the burner again. (See Resetting the
Burners, page 11.)
• The burner will shut off automatically after four
continuous hours, unless the timer for that burner is
set to shut off sooner with the auto-shutoff timer.
NOTE: If the cooktop does not function correctly, fol-
low these possible solutions:
• Check to make sure that the power cord is connected
to the electrical outlet and that power is turned on at
the circuit breaker or fuse box.
• Make sure a light switch does not interfere with the
power to the unit.
• Verify that gas is being supplied to the cooktop.
• Check to make sure that the burner rings and burner
caps are properly seated.
• Repeat the Ignition Test in Step 4.
• Read Adjusting the Low-Burner Setting, page 11.
LOCK
Clock/ Cooktop
timer ON/OFF
button
display button
Clock "+"
UP button
ON / OFF
Button
Burner Controls
11