Kenwood BL760 series Manual page 3

before plugging in
Make sure your electricity supply is
●
the same as the one shown on the
underside of the appliance.
This appliance conforms to EC
●
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
key
blender
filler cap
lid
goblet
blender sealing ring
blender blade unit
base
speed + pulse control
pre-programmed buttons
power unit
cord storage
mill (if supplied)
mill jar
mill sealing ring
mill blade unit
mill base
mill lid
to use your blender
1 Fit the sealing ring
blade unit marked
the seal is located correctly in the
grooved area.
Leaking will occur if the seal
●
is damaged or incorrectly
fitted.
2 Clip the blade unit
.
3 Screw the blade assembly onto the
goblet – ensuring the blade
assembly is fully tightened.
4 Put your ingredients into the goblet.
Never blend more than 1.6
litres or more than 1 litre for
frothy liquids like milkshakes.
5 Fit the filler cap to the lid.
to the blender
– ensuring
into the base
3
6 Fit the lid by pushing down until
secure.
7 Place the blender onto the power
unit.
The appliance won't work if
●
the blender is incorrectly
fitted.
8 Plug in and the 4 pre-program
buttons will light up.
9 Choose one of the following options:
Select one of the 4 pre-programmed
●
buttons (refer to the function selector
chart). When the required program
button is pressed the lights on the
other 3 buttons will go out. The
blender will switch off automatically
at the end of the pre-set time. If you
wish to stop before the pre-set time,
press the selected program button
again.
Select speed 1 (low) to 5 (High) by
●
turning the speed control. At the end
of blending return the speed control
to "0" before removing the blender.
(P) Pulse – operates the motor in a
●
start/stop action. The pulse will
operate for as long as it is held in
position.
NOTE: The pre-program lights will
flash under the following
circumstances
The power unit is plugged in but the
●
goblet is not fitted to the power unit.
The goblet is removed from the
●
power unit without switching the
speed control to "0".
The power unit will not operate until
●
the control is turned to "0" and a
speed is reselected.