Yamaha AW4416 Service Manual page 77

AW4416
4. Place the hard disk on the ADP25H (PN-HDD circuit board) as shown in the diagram below, align the screw
holes of the hard disk and the ADP25H (PN-HDD circuit board), and use your screwdriver to fasten the
screws at the four locations shown.
5. Plug the connector of the flat cable (HDD cable assembly VS580600) extending from the ADP25H (PN-HDD
circuit board) into the connector of the hard disk.
• Even if it is difficult to plug in the connector, do not use excessive pressure to force it in. This may damage the hard disk,
or you may injure yourself.
36
Flat cable
Flat cable connector