Use Of The Programmer - Electrolux AR 4090 Operating Instructions Manual

USE OF THE PROGRAMMER

Press button P2 on the control panel to put all the
previously programmed data into memory P2: all
the indicators on the programmer will turn Off
(the only exception being the speed 3 indicator).
Turn the machine Off before removing the
programmer.
Program P3: only suction.
Note: it is recommended to insert/remove the
programmer while the machine is in the
Off condition.
With the programmer in the panel connector
switch the machine ON; wait until the battery
voltage will appear on the display.
Select the forward running speed (button
"Speed" on the programmer).
Note: every time a button is pressed an acoustic
signal will be heared.
Enable the suction motor by pressing the
corresponding button: the suction motor will work
for a few seconds.
Press button P on the programmer to confirm the
programmed values: the corresponding indicator
will turn On.
Press button P3 on the control panel to put all the
previously programmed data into memory P3: all
the indicators on the programmer will turn Off
(the only exception being the speed 3 indicator).
Turn the machine Off before removing the
programmer.
Three different cases/examples have been
described above. For every application (different
kind of floor, of dirt to be scrubbed etc.) it will be
possible to choose the optimal automatic
program.
28
S31EUK4090SY(2)99-01