Table of Contents
Advertisement
USE OF THE PROGRAMMER
Program P2: scrubbing in ECO mode without
suction.
Note: it is recommended to insert/remove the
programmer while the machine is in the
Off condition.
With the programmer in the panel connector
switch the machine ON; wait until the battery
voltage will appear on the display.
Select the forward running speed (button
"Speed" on the programmer).
Note: every time a button is pressed an acoustic
signal will be heared.
Select the ECO mode by means of the relevant
button: an "E" will start lighting on the dispaly; in
this case it is not necessary to enable the
solution pump.
Enable the brush motors by pressing the
corresponding button: the brush motors will work
for a few seconds.
Press one time the button for the selection of the
display data: the current brush pressure will be
shown.
Choose the value 60% (i.e. P 60) using buttons
+ and - on the programmer.
Press button P on the programmer to confirm the
programmed values: the corresponding indicator
will turn On.
27
S31EUK4090SY(2)99-01
Advertisement
Table of Contents
