Table of Contents
Advertisement
A S S E M B LY I N S T R U C T I O N S
device to control the room temperature. Do not use
this heater in small rooms when they are occupied by
persons not capable of leaving the room on their
own, unless constant supervision is provided.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
TECHNICAL SPECIFICATIONS
• Amps: 12.5
• Wattage: 1500W (+5% –10%)
• Working voltage: 120V AC/60Hz
NOTE: Low Heat setting may be 1000W on some models.
ASSEMBLY INSTRUCTIONS (IF REQUIRED)
NOTE: A Phillips screwdriver is required for assembly.
Unpack your heater from box, being careful to remove
all parts from plastic bags and remaining packaging.
Please save the carton for off-season storage.
Some models are packed with separate base and pedestal
in the box. Carefully remove all parts from plastic bags.
To prevent scratches, place all parts onto a cloth before
assembly. Follow the below instructions for Pedestal/Base
assembly:
Pedestal Assembly (if no pedestal is included in this
model, move to Base Assembly)
Step 1:
Run the power cord through the center of the
assembled pedestal. Snap pedestal into the
bottom of the heater housing. Refer to Figure 1,2.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Advertisement
Table of Contents
