Ac Outlet Connections; Connecting The Power - Onkyo A-DS650 Instruction Manual

AC outlet connections

R L V
OUT OUT FRONT
R L
VIDEO-1
IN IN SURROUND
R L MULTI
CHANNEL
INPUT
OUT OUT
VIDEO-2
CENTER SUBWOOFER
IN IN
DIGITAL INPUT
DIGITAL 1
IN DVD IN
(OPTICAL)
OUT MONITOR DIGITAL 2
(REC) OUTPUT (COAXIAL)
R L
TUNER
TAPE-1
V
IN DIGITAL 3
(PLAY) (COAXIAL)
CD
OUT
(REC)
REMOTE CONTROL
OUT IN
SUBWOOFER
GND IN
(PLAY) PRE OUT
PHONO TAPE-2
R L R L
Capacity is total
100 watts.

Connecting the power

•
Before you plug in the amplifier, confirm that all connections have been made properly.
•
Before you turn on the power, make sure that the MASTER VOLUME control is fully turned counterclockwise.
•
Turning on this amplifier's power may cause a momentary power surge, which might interfere with other electrical equipment, such as
computers. If this happens, use a wall outlet on a different circuit.
STAND-BY indicator
SYSTEM button
POWER switch
SYSTEM
DOLBY SURROUND
P R O • L O G I C
Re-EQ
TM
STAND-BY
POWER
ON OFF
SPEAKERS
MAIN REMOTE
HIGH DEFINITION REC OUT
MULTIPLE SOURCE
REMOTE SYSTEM DIGITAL AUDIO
SELECTOR
PHONES
INPUT MULTI-CH DVD VIDEO-1
SELECTOR ® INPUT VCR-1
SURROUND SPEAKERS
CENTER
SPEAKER FRONT MAIN SPEAKERS
R L
R L
CAUTION: SPEAKER IMPEDANCE
6 OHMS MIN. / SPEAKER
R L
FRONT REMOTE SPEAKERS
AC OUTLETS
AC230V 50Hz
SWITCHED
TOTAL 100W MAX.
MODEL NO. A-DS650
Display
MASTER VOLUME
SMART SCAN CONTROLLER
SURROUND
ENTER
PARAMETER
3-D BASS
MIDNIGHT
Re-EQ
MULTI SOURCE THEATER
MIN MAX
BASS TREBLE
TAPE-1
VIDEO-2 TAPE-2 TUNER PHONO C D
M D MONITOR
VCR-2/TV
AUDIO VIDEO CONTROL AMPLIFIER A-DS650
You can connect the power cord from other
audio device to the rear of the A-DS650.
Since the AC outlets on the unit are the
SWITCHED type, you can use the SYSTEM
button, or the POWER button on the remote
controller to turn on/off the power to both the
A-DS650 and the connected audio devices.
Note:If your A-DS650 has a POWER (
OFF
The shape, number, and total capacity of the
AC outlets may differ depending on the area of
purchase. Make sure that the total capacity of
other components connected to this unit does
not exceed the capacity that is printed on the
rear panel.
1. Plug the power cord into an AC wall outlet.
2. Press the POWER switch to set the amplifier to
Standby mode.
The STAND-BY indicator will light up.
3. Press the SYSTEM button or POWER button on the
remote controller to turn on the amplifier. The dis-
play will light up and the STAND-BY indicator will
be turned off.
If you press the SYSTEM button or POWER button on
the remote controller again, the amplifier returns to
To wall
Standby mode.
outlet
•
You cannot use the remote controller if the POWER
switch on the amplifier is set to OFF.
) switch, first turn it on.
/
ON
13