Onkyo A-DS650 Instruction Manual page 23

Using Surround mode
STEREO parameters
1. Select the STEREO parameter.
2. Indicate whether or not you are using a subwoofer.
If you have set the System Setup's Subwoofer parameter to YES,
you can still specify whether or not you wish to use the sub-
woofer when Surround mode is STEREO. Set this parameter to
YES if you wish to use the subwoofer in STEREO mode. If you
have set the System Setup's Subwoofer parameter to NO, this
parameter will not appear.
When Multi channel input is selected as a source
1. Select Multi-channel input as an Input selector.
You cannot select any Surround mode.
2. Adjust the speaker volume.
You can adjust the volume level of each speaker individually.
Adjust them while listening to the sound from the listening posi-
tion.
Using the remote controller:
1
Press the CH-SEL button to select the desired speakers.
2
Use the LEVEL π/† button to change the volume level
of the speaker.
Using the front panel of the unit:
You can adjust the level for the left speaker, center speaker, right
speaker, right surround speaker, left surround speaker, and sub-
woofer, in this order.
The following illustration shows the relationship between the parameters
and the PARAMETER, ENTER buttons, and SMART SCAN CON-
TROLLER.
Multi-channel input
This mark indicates parameters.
PARAMETER
Left (Left speaker level)
SMART SCAN CONTROLLER
ENTER
–12, –11, ... , 0, ... , +11, +12 dB
Center (Center speaker level)
SMART SCAN CONTROLLER
ENTER
–12, –11, ... , 0, ... , +11, +12 dB
Right (Right speaker level)
SMART SCAN CONTROLLER
ENTER
–12, –11, ... , 0, ... , +11, +12 dB
R-Sur. (Right surround speaker level)
SMART SCAN CONTROLLER
ENTER
–12, –11, ... , 0, ... , +11, +12 dB
L-Sur. (Left surround speaker level)
SMART SCAN CONTROLLER
ENTER
–12, –11, ... , 0, ... , +11, +12 dB
Subwoofr (Subwoofer speaker level)
SMART SCAN CONTROLLER
ENTER
–30, –29, ... , 0, ... , +11, +12 dB
Default
SMART SCAN CONTROLLER
s
NO / YES
PARAMETER
Quit
23