Onkyo A-DS650 Instruction Manual page 27

Programming remote controller codes
1
SENDING/
LEARNED
POWER SLEEP DIMMER
TONE
Light
RC-374M
SENDING/
LEARNED
POWER SLEEP DIMMER
SENDING/
LEARNED
POWER
DVD
TAPE-1
2
REMOTE CONTROLLER
SUBROOM
A B LEARN
Switch to LEARN
TEST SUR
MODE
2
5 to 10 cm
(2 to 4 inch)
3
The button you wish to memorize
SUBROOM
A B LEARN
Switch to A
TEST SUR
MODE
TONE
SUBROOM
A B LEARN
1
TEST SUR
SLEEP DIMMER
TONE MODE
MULTI-CH
SOURCE SELECTOR
VIDEO-1 VIDEO-2 INPUT
TAPE-2 TUNER PHONO C D
SUR.
MODE
PAUSE
/STEP CH SEL
LEVEL VOLUME
MUTING
/REMOTE
SPEAKER
RC-374M
Leaning new controller codes
1. Set the A/B-SUB ROOM/LEARN selector switch to
LEARN.
2. Place the head of your old remote controller 2-4 inches
(5-10 cm) from the head of the RC-374M, laying both
units on a table or a flat surface.
3. On the RC-374M, press the button in the PROGRAM-
MABLE AREA into which you want to store the code.
•
The SENDING/LEARNED indicator lights up.
4. On your old remote controller, hold down the button
for the function you want the RC-374M to memorize
while the LEARNED indicator is lit. Keep pressing
this button until it turns off.
•
To store a code to another button, repeat steps 3-4.
NOTES:
•
Some remote controllers use a single button to perform
different functions, with the function code changing each
4
time the button is pressed. If you are using this kind of
controller, please perform the "learn" operations for each
function individually to store each function to a button on
the RC-374M.
•
For instructions regarding the operation of "learned" units,
please refer to the instruction manual for each product.
•
Even after codes have been memorized, please keep your
old remote controller in a safe place. If the memorized
codes are lost when the batteries run down, it will be nec-
essary to memorize them once again using the old remote
controller.
Reprogramming the buttons:
Follow the steps 1-4 described above. The previous codes
will be lost, and new codes will be stored.
Operating the RC-374M
Please check whether previously-memorized functions are
working properly. If the SENDING indicator is not illumi-
nated when a programmed button is pressed, it may need to
be relearned from your old remote controller.
Set the A/B-SUB ROOM/LEARN selector switch to the A
position.
Then operate the remote controller by pressing the buttons of
the functions you want to use.
•
If you press a button that has no code stored, the SEND-
ING/LEARNED indicator will not light up.
Clearing all memorized codes
1. Set the A/B-SUB ROOM/LEARN selector switch to
LEARN.
2. Press and hold the POWER and VOLUME † buttons
together until the SENDING/LEARNRED indicator
turns off.
•
All codes stored in the programmable area will be
deleted.
27