Engine Shut-Off Cord (Lanyard) And Clip; Engine Stop Button; Choke Knob For Pull Type; Manual Starter Handle - Yamaha F4A Owner's Manual

Components
EMU25993
Engine shut-off cord (lanyard) and
clip
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power. WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not
route the cord where it could become en-
tangled, preventing it from functioning.
Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power, the
boat could slow rapidly. This could cause
people and objects in the boat to be
thrown forward.
[EWM00122]
1. Cord
2. Clip
3. Engine shut-off switch
EMU26001

Engine stop button

To open the ignition circuit and stop the en-
gine, push this button.
19
EMU26011

Choke knob for pull type

To supply the engine with the rich fuel mix-
ture required to start, pull out this knob.
EMU26070

Manual starter handle

To start the engine, first gently pull the han-
dle out until resistance is felt. From that posi-
3
2
tion, then pull the handle straight out quickly
to crank the engine.
1
ZMU02667
ZMU02668
ZMU02669
ZMU02670