Checks After Engine Warm-Up; Shifting; Stop Switches - Yamaha F4A Owner's Manual

Operation
TIP:
If the choke knob is left pulled out after the
●
engine starts, the engine will stall.
In temperatures of -5°C or less, leave the
●
choke knob pulled out fully for approxi-
mately 30 seconds after starting.
EMU36530

Checks after engine warm-up

EMU36540

Shifting

While tightly moored, and without applying
throttle, confirm that the engine shifts
smoothly into forward and reverse, and back
to neutral.
EMU36970

Stop switches

Press the engine stop button and make
●
sure the engine stops.
Confirm that removing the clip from the en-
●
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
●
with the clip removed from the engine
shut-off switch.
EMU34610
Shifting
EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01610
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
1. Move the gear shift lever firmly and
33
crisply forward (for forward gear) or
backward (for reverse gear).
R
To shift from in gear (forward/reverse) to
neutral
1. Close the throttle so that the engine
slows to idle speed.
2. After the engine is at idle speed in gear
move the gear shift lever firmly and
crisply into the neutral position.
N
F
ZMU05923
ZMU02685
N
ZMU02682