Disassembly - JVC KW-XC939 Service Manual

3.1 Main body
3.1.1 Removing the front panel assembly
(See Fig.1, 2)
(1) From the both side of the main body, remove the four screws
A attaching the front panel assembly. (See Figs.1, 2)
(2) Release the four joints a using a screwdriver, then remove
the front panel assembly toward the front. (See Figs.1, 2)
3.1.2 Removing the rear bracket
(See Figs.3)
• Prior to performing the following procedure, remove the front
panel assembly as required.
(1) From the back side of the main body, remove the ten
screws B, screw C and screw D attaching the rear bracket.
(2) Take out the rear bracket.
3.1.3 Removing the heat sink
(See Fig.4)
• Prior to performing the following procedure, remove the front
panel assembly as required.
(1) From the left side of the main body, remove the two screws
E and three screws F attaching the heat sink.
1-6 (No.MA041)
SECTION 3

DISASSEMBLY

A
A
Joints a
B
B
B
F
Front panel assembly
Joints a
Fig.1
Front panel assembly
Fig.2
C B
Fig.3
E F
Fig.4
A
A
D
Rear braket
Heat sink
F