JVC KW-XC939 Service Manual page 10

3.1.10 Removing the cassette mechanism assembly
(See Fig.14)
• Prior to performing the following procedures, remove the front
panel assembly, rear bracket, heat sink, bottom chassis as-
sembly, changer control board and mecha control board.
(1) From the bottom side of the bottom chassis assembly, re-
move the four screws N attaching the cassette mechanism
assembly to the bottom chassis assembly.
3.1.11 Removing the LCD board
(See Fig.15)
• Prior to performing the following procedures, remove the front
panel assembly.
(1) From the back side of front panel assembly, remove the
twelve screws P attaching the LCD board, and then turn
over the LCD board.
(2) From the reverse side of LCD board, remove the solders
from the soldered points j attaching the wire.
3.1.12 Removing the switch board
(See Fig.16)
• Prior to performing the following procedures, remove the front
panel assembly.
(1) From the back side of front panel assembly, remove the
five screws Q attaching the switch board.
(2) Release the claws k attaching the switch board, and then
turn over the switch board.
(3) From the reverse side of switch board, remove the solders
from the soldered points m attaching the wire.
1-10 (No.MA041)
N
N
Cassette mechanism assembly
Fig.14
Front panel assembly
P
P
LCD board
Fig.15
Front panel assembly
Q
Claws k
Fig.16
Bottom chassis assembly
P
P
Solder points j
Solder points m
Q
Switch board