Table of Contents
Advertisement
M ounti ng t he i nver ter
6
Mounting the inverter
DANGER
Risk of fatal injury from fire or explosions
Fire caused by flammable or explosive materials in the vicinity of the inverter can lead to serious
injuries.
›
Do not mount the inverter in an area at risk of explosion or in the vicinity of highly flammable
materials.
CAUTION
Risk of burns from hot housing components.
Coming into contact with the housing can cause burns.
›
Mount the inverter so that it cannot be touched unintentionally.
CAUTION
Risk of injury if the inverter tips over!
Risk of tipping with high centre of gravity, particularly with the door open.
›
Anchor the inverter securely to the ground immediately after positioning it and, if possible,
also fasten it to the wall.
›
Do not open the housing door until the inverter has been securely anchored.
Installation space
•
As dry as possible, climate-controlled, with the waste heat dissipated away from the inverter,
•
Unobstructed air circulation,
•
When installing the unit in a control cabinet, provide forced ventilation so that the heat is sufficiently dissipated,
•
Close to the ground, accessible from the front and sides without requiring additional resources
•
Protected from direct sunshine outdoors,
•
For easy operation, ensure during installation that the display is slightly below eye level.
Floor and wall
•
With sufficient load-bearing capacity,
•
Accessible for installation and maintenance,
•
Made from heat-resistant material (up to 90 °C),
•
Flame resistant,
•
Minimum clearances to be observed during assembly: see Figure 4 on page 15 and Figure 5 on page 16.
NOTE
Access by maintenance personnel for service
Any additional costs arising from unfavourable structural or mounting conditions shall be billed to
the customer.
Page 14
Operating Instructions Powador 30.0-72.0 TL3_EN
Hide quick links:
Advertisement
Table of Contents
