Download Print this page

The Source SOURCE04BLP Owner's Manual page 24

Advertisement

NG Model Only
15
Connecting Natural Gas To Your Grill
For Natural Gas grills: Connect the grill end of
the 12' Natural Gas Hose to the horizontal fitting
as shown. Connect the hose end to the gas
supply line. Also, read the natural gas safety
instructions on page 4.
SIDE BURNER
GAS VALVE ASSEMBLY
SIDE BURNER
EXTENSION HOSE
Congratulations
Your gas grill is now ready for use. Before
the first use and at the beginning of each
season (and whenever the LP gas tank has
been changed):
1.
Read all safety, lighting and operating
instructions.
2.
Check Gas Valve Orifices, Burner Tubes
and Burner Ports for any obstructions.
3.
Perform gas leak check according to
instructions found on
manual.
HOSE, 12 ft./NG
page 24
of this
!
If you smell gas:
Shut off gas supply to the gas grill.
Turn the Control Knobs to OFF position.
Extinguish any open flame such as candle,
cigarette, lighter, etc., that could cause gas
to ignite.
Open the Grill Lid.
Get away from the LP gas tank.
Do not try to fix the problem yourself.
If odor continues or you have a fire you
cannot extinguish, call your fire depart-
ment.
Do not call near the LP gas tank
because your telephone is an electrical
device and could create a spark resulting
in fire and/or explosion.
NOTE: The normal flow of gas through the
regulator and hose assembly can create a
humming noise. A low volume of noise is
perfectly normal and will not interfere with
operation of the grill. If humming noise is
loud and excessive you may need to purge
air from the gas line or reset the regulator
excess gas flow device. This purging proce-
dure should be done every time a new LP
gas tank is connected to your grill. For help
call the Grill Information Center.
Grill Information Center:
8:00am - 4:30pm CST, Monday through
Friday 1-877-934-7455
Checking For LP Gas Leaks
Never test for leaks with a flame. Prior to first
use, at the beginning of each season, or every
time your LP gas tank is changed, you must
check for gas leaks. Follow these four steps:
1.
Make a soap solution by mixing one part
liquid detergent and one part water.
2.
Turn the grill Control Knobs to the full OFF
position, then turn the gas ON at source.
3.
Apply the soap solution to all gas connec-
tions. If bubbles appear in the soap solution
the connections are not properly sealed.
Check each fitting and tighten or repair as
necessary.
If you have a gas leak that cannot be re-
4.
paired by tightening, turn off the gas at the
source, disconnect fuel line from your grill and
call 1-877-934-7455 or your gas supplier for
repair assistance.
24
WARNING

Advertisement

loading

Related Products for The Source SOURCE04BLP

This manual is also suitable for:

Source04bng